Are you tired of the constant drip, drip, drip of a leaky bath tap keeping you up at night? Don’t worry, we’ve got you covered. In this step-by-step guide, we’ll walk you through the process of fixing a leaky bath tap so you can finally get a good night’s sleep.
Introduction
Leaky taps are not only annoying, but they can also lead to wasted water and increased utility bills. Fortunately, fixing a leaky bath tap is a relatively simple DIY project that can be completed in just a few hours.
Step 1: Gather Your Tools
The first step in fixing a leaky bath tap is to gather all the necessary tools and materials. You’ll need an adjustable wrench, a screwdriver, a pair of pliers, a replacement washer, and some plumber’s tape. Make sure to turn off the water supply to the tap before you begin.
Step 2: Remove the Tap Handle
Use the screwdriver to remove the screw that holds the tap handle in place. Once the screw is removed, you can carefully lift off the handle to expose the inner workings of the tap.
Step 3: Replace the Washer
Next, use the wrench to loosen the nut that holds the tap cartridge in place. Once the nut is removed, you can take out the cartridge and inspect the washer. If the washer is worn or damaged, replace it with a new one. Make sure to use the plumber’s tape to seal any gaps and prevent leaks.
Step 4: Reassemble the Tap
Once you’ve replaced the washer and sealed any gaps with plumber’s tape, it’s time to reassemble the tap. Put the cartridge back in place, tighten the nut with the wrench, and reattach the tap handle with the screwdriver. Turn the water supply back on and test the tap to make sure the leak has been fixed.
Conclusion
Fixing a leaky bath tap is a simple DIY project that can save you time and money in the long run. By following this step-by-step guide, you can easily repair a leaky tap and enjoy a quiet and leak-free bath. If you have any questions or tips on fixing a leaky bath tap, feel free to leave a comment below.